10
Canoga Perkins 2201 Rack Chassis/2200R Redundant Card
Unit Setting
Chassis Backplane W1: Installed
Power Monitor Board S2: A if single power supply
A+B if redundant power supply
W2: Installed
W4: Installed
Table 2-A.
2201 Rack Chassis
Factory Settings
2.1.1 FX-23 Extender Bracket
The Canoga Perkins Extender Bracket, FX-23, enables the 2201 Rack Chassis to be
installed in a 23-inch equipment rack. Figure 2-3 shows the FX-23 Extender Bracket
and the rack assembly.
To install the bracket, use the following steps :
Step 1: Attach the FX-23 Extender Bracket on the left side of the rack assembly
(as viewed from the front) with the appropriate screws. (The FX-23 must
be installed on the opposite side of the power supplies due to weight
considerations.)
Step 2: Attach the rack assembly to the equipment rack frame with the appropri-
ate screws.
Comments to this Manuals